LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Honda >> 1987 >> Prelude Base, Standard >> Repair and Diagnosis >> Engine Performance >> System >> PGM-FI Electronic Control System >> Testing >> Code 13, Atmospheric (Pa) Sensor
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Code 13, Atmospheric (Pa) Sensor

  1. Turn off ignition. Remove clock fuse in the under-hood relay box for 10 seconds to reset ECU. Start engine and observe PGM-FI warning light. If light is off, problem is intermittent. Test drive and check again.
  2. If light is on, turn ignition off. Connect system checker harness between ECU and ECU connector. Turn ignition on. Measure voltage between terminals C13 (pos.) and C12 (neg.). If about 5 volts is red, go to step 3). If not, substitute a known good ECU. If correct voltage is now indicated, replace original ECU.
  3. Measure voltage between terminals C9 (pos.) and C12 (neg.). If about 3 volts is not present, go to step 4). If about 3 volts is present, substitute a known good ECU. If condition is rectified, replace original ECU.
  4. Disconnect connector from atmospheric pressure sensor. Measure voltage between terminals C9 (pos.) and C12 (neg.) on harness side. If about 5 volts is indicated, go to step 5). If about 5 volts is not indicated, repair short in Red wire between ECU terminal C9 and sensor.
  5. Measure voltage between White/Yellow and Green/White (neg.) wires. If reading is not about 5 volts, go to step 6). If about 5 volts is present, measure voltage between Red and Green/White (neg.) terminals. If about 5 volts is not read, repair open Red or Red/White wire between ECU terminal C9 and sensor. If about 5 volts is red, replace sensor.
  6. Measure voltage between ground and White/Yellow wire of harness. If about 5 volts is not present, repair open in White/Yellow or Yellow/White wire between ECU terminal C13 and sensor. If about 5 volts is present, repair open Green/White wire between ECU terminal C12 and sensor.