LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Honda >> 2000 >> CR-V EX, Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls Self-Diagnostics >> Diagnostic Tests >> DTC P1106: BARO Sensor Range/Performance Problem
April 5, 2026: LEMON Manuals is launched! Read the announcement.

DTC P1106: BARO Sensor Range/Performance Problem

  1. Perform PCM reset procedure. See SELF-DIAGNOSTICS - INTRODUCTION article. Start engine and run at 3000 RPM with no loads and transmission in Park or Neutral until radiator fan comes on. Allow engine to idle. Connect SCS Service Connector (07PAZ-0010100) to 2-pin service check connector located behind right side of center console.
  2. Test drive vehicle with transmission in "2" position (A/T) or in 4th gear (M/T). Accelerate for 5 seconds with Wide Open Throttle (WOT). If DTC P1106 is not indicated, problem is intermittent. System is okay at this time. If DTC P1106 is indicated, substitute a known good PCM and recheck. See SUBSTITUTING PCM in SELF-DIAGNOSTICS - INTRODUCTION article. If symptom or indication goes away, replace original PCM.
scientia non olet · About LEMON Manuals