ABS Modulator-Control Unit Removal and Installation: Installation
- Install the ABS modulator-control unit on the bracket, then tighten the two 6 mm nuts.
- Connect the six brake lines to the ABS modulator-control unit, and tighten the flare nuts to the specified torque.
- Align the connecting surface of the ABS modulator-control unit 25P connector.
- Push in the lock of the ABS modulator-control unit 25P connector until you hear it click into place, then connect the connector.
- Bleed the brake system, starting with the front wheels (see BRAKE SYSTEM BLEEDING ).
- Start the engine, and check that the ABS indicator goes off.
- Test-drive the vehicle, check the ABS operation, and check that the ABS indicator does not come on.
- If the brake pedal is now spongy, there may be air trapped in the modulator and then induced into the normal brake system during modulation. Bleed the brake system again, starting with the front wheels (see BRAKE SYSTEM BLEEDING ).