LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Honda >> 2000 >> Insight >> Repair and Diagnosis >> Engine Performance >> Fuel Delivery >> Fuel And Emissions Systems >> How to Set Readiness Codes >> Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

How to Set Readiness Codes: Procedure

  1. Connect the HDS to the vehicle's data link connector (DLC), and bring up the READINESS CODEs screen for Catalyst in the DTCs MENU.
  2. Start the engine.
  3. Test-drive the vehicle under stop-and-go conditions with short periods of steady cruise. After about 5 miles (8 km), the readiness code should switch to complete.
  4. If the readiness code is still not set to complete, check for a Temporary DTC with the HDS. If there is no DTC, one or more of the enable criteria were probably not met; repeat the procedure.


  1. Connect the HDS to the vehicle's data link connector (DLC).
  2. Start the engine.
  3. Select EVAP TEST in the INSPECTION MENU with the HDS, then select the FUNCTION TEST in the EVAP TEST MENU.
    • If the result is normal, readiness is complete.
    • If the result is not normal, go to the next step.
  4. Check for a Temporary DTC. If there is no DTC, one or more of the enable criteria were probably not met; repeat the procedure.


  1. Start the engine.
  2. Test-drive the vehicle under stop-and-go conditions with short periods of steady cruise. During the drive, decelerate (with the throttle fully closed) for 5 seconds. After about 3.5 miles (5.6 km), the readiness code should switch from incomplete to complete.
  3. Check the readiness codes screen for the AIR FUEL RATIO (A/F) SENSOR in the DTCs MENU with the HDS.
    • If the screen shows complete, readiness is complete.
    • If the screen shows not complete, go to the next step.
  4. Check for a temporary DTC. If there is no DTC, the enable criteria was probably not met. Select the DATA LIST Menu. Check the ECT in the ALL DATA LIST with the HDS. If the ECT is lower than 140°F (60°C), run the engine until it is higher than 140°F (60°C), then repeat the procedure.


  1. Connect the HDS to the vehicle's data link connector (DLC).
  2. Start the engine, and let it idle for 1 minute. The readiness code should switch from incomplete to complete.
  3. If the readiness code is still set to incomplete, check for a Temporary DTC. If there is no DTC, repeat the procedure.


  1. Connect the HDS to the vehicle's data link connector (DLC).
  2. Start the engine.
  3. Drive at a steady speed with the CVT in D position or M/T in 4th gear, 50-62 mph (80-100 km/h), or above for more than 10 seconds.
  4. With the CVT in D position or M/T in 4th gear, decelerate from 62 mph (100 km/h) or above by completely releasing the throttle for at least 5 seconds. If the engine is stopped during this procedure, go to step  3 and do the procedure again.
  5. Check the OBD status for DTC P0401 in the DTCs MENU with the HDS.
    • If it is passed, readiness is complete.
    • If it is not passed, go to step  3 and retest.
scientia non olet · About LEMON Manuals