Ignition Switch/Steering Lock: Test

SRS components are located in this area. Review the SRS component locations, (see COMPONENT LOCATION INDEX ) and PRECAUTIONS AND PROCEDURES ) before performing repairs or service.

1. Make sure you have the anti-theft code for the radio, then write down the frequencies for the radio's preset buttons.
2. Disconnect the battery negative cable.
3. Disconnect the 7P connector from the under-dash fuse/relay box.
   Fig 1: Disconnecting 7P Connector From Under-Dash Fuse/Relay Box

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
4. Check for continuity between the terminals in each switch position according to the table below.
   Fig 2: Identifying Ignition Switch Continuity Check Table

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
5. If the continuity checks do not agree with the table, replace the electrical switch.