Bleeding Procedures
NOTE:
Do not reuse drained fluid. Always use Honda Genuine DOT 3 Brake Fluid. Ensure no dirt or other materials enter brake fluid. Do not spill brake fluid on vehicle, it may damage paint; if some does spill, wash off immediately with water. The reservoir on master cylinder must be at the MAX (upper) level mark at start of bleeding procedure and checked after bleeding each brake caliper. Add fluid as required.
Raise and support vehicle. Fill master cylinder to maximum using only genuine Honda DOT 3 brake fluid. Have someone slowly pump brake pedal several times, then apply steady pressure. Loosen left-front brake bleed screw to allow air to escape from system. Then tighten bleed screw securely. Repeat procedure for each wheel in sequence. Bleeding sequence is FL, FR, RR and RL.