Master Switch Test

Remove the driver's door panel (see DOOR PANEL REMOVAL/INSTALLATION ).
Disconnect the 14P connector from the power window master switch.

Fig 1: Disconnecting 14P Connector From Power Window Master Switch
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Check for continuity between the terminals in each switch position according to the table below.
Driver's Switch

NOTE: The driver's switch is combined with the control unit so you cannot isolate the switch to test it. Instead, run the master switch input test procedures (see step 6 ).

Passenger's Switch
If the continuity is not as specified, replace the switch.

Fig 2: Identifying Passenger's Switch Continuity Table
Courtesy of AMERICAN HONDA MOTOR CO., INC.