DTC P0116: ECT Sensor 1 Range/Performance Problem
- Turn the ignition switch ON (II).
- Check ECT SENSOR 1 in the DATA LIST with the HDS.
Is about 176°F (80°C) or more, or 0.78 V or less indicated?
YES - Go to step 6.
NO - Go to step 3.
- Note the value of ECT SENSOR 1 in the DATA LIST with the HDS.
- Start the engine. Hold the engine speed at 3,000 rpm without load (in Park or neutral) until the radiator fan comes on, then let it idle.
- Check ECT SENSOR 1 in the DATA LIST with the HDS.
Does ECT SENSOR 1 change 18°F (10°C) or more?
YES - Intermittent failure, system is OK at this time. Check for poor connections or loose terminals at the ECT sensor 1 and the PCM.
NO - Go to step 11.
- Note the value of ECT SENSOR 1 in the DATA LIST with the HDS.
- Turn the ignition switch OFF.
- Open the hood, and let the engine cool for 3 hours.
- Turn the ignition switch ON (II).
- Check ECT SENSOR 1 in the DATA LIST with the HDS.
Does ECT SENSOR 1 change 18°F (10°C) or more?
YES - Intermittent failure, system is OK at this time. Check for poor connections or loose terminals at the ECT sensor 1 and the PCM.
NO - Go to step 11.
- Turn the ignition switch OFF.
- Replace ECT sensor 1 (see ECT SENSOR 1 REPLACEMENT ).
- Turn the ignition switch ON (II).
- Reset the PCM with the HDS.
- Do the PCM idle learn procedure (see PCM IDLE LEARN PROCEDURE ).
- Check for Temporary DTCs or DTCs with the HDS.
Are any Temporary DTCs or DTCs indicated?
YES - If DTC P0116 is indicated, check for poor connections or loose terminals at the ETC sensor 1 and the PCM, then go to step 1. If any other Temporary DTSs or DTCs are indicated, go to the indicated DTC'S TROUBLESHOOTING .
NO - Troubleshooting is complete.