Key Interlock Solenoid Test

SRS components are located in this area. Review the SRS component locations (see COMPONENT LOCATION INDEX ) and the precautions and procedures (see PRECAUTIONS AND PROCEDURES ) before doing repairs or service.

1. Remove the driver's dashboard lower cover (see DRIVER'S DASHBOARD LOWER COVER REMOVAL/INSTALLATION ) and the lower steering column cover (see STEERING COLUMN REMOVAL AND INSTALLATION ).
2. Disconnect the steering lock assembly connector.
3. Insert the ignition key in the key cylinder, then turn the ignition switch to ACCESSORY (I).
4. Connect the battery positive terminal to steering lock assembly connector terminal No. 4, and connect the battery negative terminal to No. 3 terminal. Make sure that the ignition switch cannot be turned to LOCK (0). Release the battery terminals, and make sure that the ignition switch can be turned to LOCK (0) and removed from the cylinder.
   Fig 1: Connecting Battery Positive Terminal To Steering Lock Assembly Connector Terminal 4 And Battery Negative Terminal To 3

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
5. If the key interlock solenoid works improperly, replace the ignition key cylinder/steering lock assembly (see STEERING LOCK REPLACEMENT ).