Selector Control Shaft Bearing Replacement

Special Tools Required 

• Driver handle, 15 x 135L 07749-0010000
• Attachment, 22 x 24 mm 07746-001A800

1. Remove the oil seal from the end cover, then remove the bearing.
   Fig 1: Removing Oil Seal From End Cover

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
2. Install a new bearing flush to the end cover using the driver handle and the 22 x 24 mm attachment.
   Fig 2: Installing Bearing Flush To End Cover

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
3. Install a new oil seal.