DTC P0603: ECM/PCM Internal Control Module Keep Alive Memory (KAM) Error
NOTE:
Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information (see
GENERAL TROUBLESHOOTING INFORMATION
).
- Turn the ignition switch ON (II).
- Clear the DTC with the HDS.
- Check for Temporary DTCs or DTCs with the HDS.
Is DTC P0603 indicated?
YES - Go to step 4.
NO - Intermittent failure, the system is OK at this time.
- Update the ECM/PCM if it does not have the latest software (see UPDATING THE ECM/PCM ), or substitute a known-good ECM/PCM (see SUBSTITUTING THE ECM/PCM ).
- Check for Temporary DTCs or DTCs with the HDS.
Is DTC P0603 indicated?
YES - If the ECM/PCM was updated, substitute a known-good ECM/PCM (see SUBSTITUTING THE ECM/PCM ), then recheck. If the ECM/PCM was substituted, go to step 1.
NO - If the ECM/PCM was updated, troubleshooting is complete. If the ECM/PCM was substituted, replace the original ECM/PCM (see ECM/PCM REPLACEMENT ). If any other Temporary DTCs or DTCs are indicated, go to the indicated DTCs troubleshooting.