Low Fuel Indicator Test
- Do the fuel gauge sending unit test (see FUEL GAUGE SENDING UNIT TEST
).
- If the system is OK, go to step 2.
- If the system has any malfunction, repair it.
- Turn the ignition switch OFF. Remove the No. 25 BACK UP (7.5 A) fuse from the under-dash fuse/relay box for at least 30 seconds, then reinstall it.
- Turn the ignition switch ON (II) with the float at the E (EMPTY) position.
- If the low fuel indicator is on, go to step 4.
- If the low fuel indicator is not on, refer to the low fuel indicator Circuit Diagram (see
DTC TROUBLESHOOTING INDEX
), and check the circuit.
- Turn the ignition switch OFF. Remove the No. 25 BACK UP (7.5 A) fuse from the under-dash fuse/relay box for at least 30 seconds, then reinstall it.
- Lift the float above the LOW position.
- If the low fuel indicator goes off, the system is OK.
- If the low fuel indicator is still on, refer to the low fuel indicator Circuit Diagram (see
DTC TROUBLESHOOTING INDEX
), and check the circuit.