DTC P0451: FTP Sensor Range/Performance Problem
- Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information (see GENERAL TROUBLESHOOTING INFORMATION ).
- If DTC P2422 is stored at the same time as DTC P0451, troubleshoot DTC P2422 first, then recheck for DTC P0451.
- Turn the ignition switch to ON (II).
- Clear the DTC with the HDS.
- Start the engine, and let it idle for 1 minute.
- Monitor the OBD STATUS for DTC P0451 in the DTCs MENU with the HDS.
Does the HDS indicate FAILED?
YES -Go to step 5.
NO -If the HDS indicates PASSED, intermittent failure, the system is OK at this time. Check for poor connections or loose terminals at the FTP sensor and the ECM/PCM. If the HDS indicates NOT COMPLETED, keep idling until a result comes on.
- Turn the ignition switch to LOCK (0).
- Replace the FTP sensor (see FTP SENSOR REPLACEMENT ).
- Turn the ignition switch to ON (II).
- Reset the ECM/PCM with the HDS.
- Do the ECM/PCM idle learn procedure (see ECM/PCM IDLE LEARN PROCEDURE ).
- Start the engine, and let it idle for 1 minute.
- Check for Pending or Confirmed DTCs with the HDS.
Is DTC P0451 indicated?
YES -Check for poor connections or loose terminals at the FTP sensor and the ECM/PCM. Also check the FTP vent for restrictions, then go to step 1.
NO -Go to Step 12.
- Monitor the OBD STATUS for DTC P0451 in the DTCs MENU with the HDS.
Does the HDS indicate PASSED?
YES -Troubleshooting is complete. If any other Pending or Confirmed DTCs were indicated in step 11, go to the indicated DTC'S TROUBLESHOOTING .
NO -If the HDS indicates FAILED, check for poor connections or loose terminals at the FTP sensor and the ECM/PCM, then go to step 1. If the HDS indicates NOT COMPLETED, keep idling until a result comes on.