ABS Modulator-Control Unit Removal and Installation: Installation

Install the ABS modulator-control unit onto the bracket.
Install the bracket with the ABS modulator-control unit to the body.
Reconnect the six brake lines, then tighten the flare nuts to the specified torque.
Align the connecting surface of the ABS modulator-control unit 47P connector to the ABS modulator-control unit.
Pull up the lever of the ABS modulator-control unit 47P connector, then confirm the connector is fully seated.
Bleed the brake system (see BRAKE SYSTEM BLEEDING ).
Start the engine, and check that the ABS, and the brake system indicators (amber) go off.
Test-drive the vehicle, and make sure that the ABS, and the brake system indicators (amber) does not come on.
NOTE: If the brake pedal is spongy, there may be air trapped in the modulator which could then be induced into the normal brake system during modulation. Bleed the brake system again (see BRAKE SYSTEM BLEEDING ).