DTC 104-12: Yaw Rate-Acceleration Sensor Power Source Malfunction
NOTE:
Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information (see GENERAL TROUBLESHOOTING INFORMATION
).
- Turn the ignition switch to ON (II).
- Clear the DTC with the HDS.
- Turn the ignition switch to LOCK (0) and then back to ON (II).
- Check for DTCs with the HDS.
Is DTC 104-12 indicated?
YES -If DTC 61-11 or 62-11 is indicated, check the battery BATTERY TEST , and troubleshoot the alternator regulator circuit ALTERNATOR AND REGULATOR CIRCUIT TROUBLESHOOTING . If DTC 61-11 or 62-11 is not indicated, replace the yaw rate-lateral acceleration sensor (see YAW RATE-LATERAL ACCELERATION SENSOR REPLACEMENT ).
NO -Intermittent failure, the system is OK at this time. Refer to INTERMITTENT FAILURES TROUBLESHOOTING