VSA Modulator-Control Unit Removal and Installation: Installation
- Install the VSA modulator-control unit onto the bracket.
- Install the bracket with the VSA modulator-control unit to the body.
- Reconnect the six brake lines, then tighten the flare nuts to the specified torque.
- Align the connecting surface of the VSA modulator-control unit 36P connector to the VSA modulator-control unit.
- Pull up the lever of the VSA modulator-control unit 36P connector, then confirm the connector is fully seated.
- Install the washer reservoir WASHER RESERVOIR REPLACEMENT
- Bleed the brake system BRAKE SYSTEM BLEEDING
- Do the VSA modulator-control unit update (see VSA MODULATOR-CONTROL UNIT UPDATE ).
- Do the VSA sensor neutral position memorization procedure (see YAW RATE-LATERAL ACCELERATION SENSOR REPLACEMENT ).