DTC P060A: PCM (A/T system) Internal Control Module Malfunction
NOTE:
Before you troubleshoot, record all freeze data and any on-board snapshot, and review GENERAL TROUBLESHOOTING INFORMATION
.
- Turn the ignition switch to ON (II).
- Clear the DTC with the HDS.
- Check for Pending or Confirmed DTCs with the HDS.
Is DTC P060A indicated?
YES: Go to step 4.
NO: Intermittent failure, the system is OK at this time.
- Update the PCM if it does not have the latest software (see ECM/PCM UPDATE ), or substitute a known-good PCM (see SUBSTITUTING THE ECM/PCM ).
- Check for Pending or Confirmed DTCs with the HDS.
Is DTC P060A indicated?
YES: If the PCM was updated, substitute a known-good PCM (see SUBSTITUTING THE ECM/PCM ), then recheck. If the PCM was substituted, go to step 1.
NO: If the PCM was updated, troubleshooting is complete. If the PCM was substituted, replace the original PCM (see ECM/PCM REPLACEMENT ). If any other Pending or Confirmed DTCs are indicated, go to the indicated DTC's troubleshooting.