Hatch Release Actuator Test

Open the hatch.
Remove the hatch lower trim panel (see TRIM REMOVAL/INSTALLATION - HATCH AREAS ).
Disconnect the 2P connector (A) from the hatch latch (B).

Fig 1: Identifying Hatch Latch 2P Connector Terminals
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily.

Fig 2: Hatch Latch 2P Connector Terminals Chart
Courtesy of AMERICAN HONDA MOTOR CO., INC.
If the actuator does not operate as specified, the actuator is faulty; replace the hatch latch (see HATCH LATCH REPLACEMENT ).