Throttle Body Cleaning
CAUTION:
Do not insert your fingers into the installed throttle body when you turn the ignition switch to ON (II) or while the ignition switch is ON (II). If you do, you will seriously injure your fingers if the throttle valve is activated.
- Check for damage to the air cleaner. If the air cleaner is damaged, replace it (see AIR CLEANER ELEMENT INSPECTION/REPLACEMENT ).
- Remove the throttle body (see THROTTLE BODY REMOVAL/INSTALLATION ).
- Clean off the carbon from the throttle valve and inside the throttle body with a paper towel soaked in throttle plate cleaner.NOTE:
- Remove the throttle body to clean it.
- Be careful not to pinch your fingers.
- To avoid removing the molybdenum coating, do not clean the bearing area of the throttle shaft (A).
- Do not spray throttle plate and induction cleaner directly on the throttle body.
- Use Honda genuine throttle plate cleaner.
- Install the throttle body (see THROTTLE BODY REMOVAL/INSTALLATION ).
- Reset the PCM with the HDS (see HDS CLEAR COMMAND ).
- Turn the ignition switch to ON (II), and wait 2 seconds.
- Do the PCM idle learn procedure (see PCM IDLE LEARN PROCEDURE ).