Back Window Middle Glass Regulator Replacement
NOTE:
- Put on gloves to protect your hands.
- Take care not to bend or scratch the trim or the panels.
- Remove these items:
- Rear seat assembly (see REAR SEAT REMOVAL/INSTALLATION )
- C-pillar trim, both sides (see C-PILLAR TRIM )
- Rear seat belt lower anchor (see REAR SEAT BELT REPLACEMENT )
- Rear seat side trim, both sides (see TRIM REMOVAL/INSTALLATION - DOOR AREAS )
- Subwoofer for some models (see SUBWOOFER )
- Rear panel insulator (see REAR PANEL INSULATOR REPLACEMENT )
- Remove the back window middle glass mounting bolts.
- Disconnect the connector (A) from the regulator motor (B).
- Remove the bolts (C, D), and detach the cable clips (E), then remove the regulator (F) and motor.
- Apply multipurpose grease to the sliding surfaces of the regulator (A) where shown.
- Install the regulator in the reverse order of removal, and note these items:
- Slide the glass right and left to make sure it moves freely without binding.
- Make sure the connector is plugged in properly.