Start Clutch Pressure Control Calibration Procedure mode

Connect the HDS to the DLC (A) located under the driver's side of the dashboard.

Fig 1: Identifying Data Link Connector (DLC)
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Turn the ignition switch to ON (II).
Make sure the HDS communicates with the PCM, and go to the A/T Data List. If it does not, go to the DLC circuit troubleshooting (see DLC CIRCUIT TROUBLESHOOTING ).
Follow the HDS screen prompts in the Start Clutch Feedback Learn (see the HDS Operator's manual).
Test-drive the vehicle for several minutes, make sure the engine does not stall or flare when starting off, and verify that a problem does not occur on the start clutch pressure control system.