Power Window Master Switch Test

Remove the power window master switch (see POWER WINDOW MASTER SWITCH REPLACEMENT ).
Disconnect the 22P connector (A) from the power window master switch (B).

Fig 1: Identifying Power Window Master Switch 22P Connector Terminals
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Check for continuity between the terminals in each position according to the tables.
Front Passenger's Switch

Fig 2: Front Passenger's Switch Continuity Chart
Courtesy of AMERICAN HONDA MOTOR CO., INC.

Left Rear Switch

Fig 3: Left Rear Switch Continuity Chart
Courtesy of AMERICAN HONDA MOTOR CO., INC.

Right Rear Switch

Fig 4: Right Rear Switch Continuity Chart
Courtesy of AMERICAN HONDA MOTOR CO., INC.

Driver's Switch

The driver's switch is combined with the control unit so you cannot isolate the switch to test it.

Instead, run the power window master switch input test procedures (see POWER WINDOW MASTER SWITCH INPUT TEST ). If the tests are normal, the driver's switch must be faulty; replace the power window master switch.
If the continuity is not as specified, replace the switch (see POWER WINDOW MASTER SWITCH REPLACEMENT ).