VSA Modulator-Control Unit Inputs and Outputs for 36P Connector

Fig 1: Identifying VSA Modulator-Control Unit 36P Connector Terminals

Courtesy of AMERICAN HONDA MOTOR CO., INC.

Terminal number	Wire color	Terminal sign	Description	Signal
1	RED	CANL	F-CAN communication circuit	---
3	LT BLU	K-LINE	Communication with HDS
4	LT GRN	RR-GND	Detects right-rear wheel speed sensor signal
6	GRY	FL-GND	Detects left-front wheel speed sensor signal
8	GRY/RED	RL-GND	Detects left-rear wheel speed sensor signal
9	YEL	SVCC	Power source for the steering angle sensor	With ignition switch ON (II): about 5.0 V
10	PNK	FR-GND	Detects right-front wheel speed sensor signal	----
11	BLK	STR-A	Detects steering angle sensor signal
12	LT GRN	FSR+B	Power source for the fail-safe relay	Battery voltage (about 12 V) at all times
13	RED	MR+B	Power source for the motor relay	Battery voltage (about 12 V) at all times
14	WHT	CANH	F-CAN communication circuit	----
18	BRN	RR + B	Detects right-rear wheel speed sensor signal
19	ORN	FL+B	Detects left-front wheel speed sensor signal
21	YEL/RED	RL+B	Detects left-rear wheel speed sensor signal	----
23	GRN	FR + B	Detects right-front wheel speed sensor signal
25	GRY	WEN	Detects write enable signal
26	BLU/ORN	STR-Z	Detects steering angle sensor signal
27	PUR	STR-B	Detects steering angle sensor signal
30	ORN	IG1	Power source for activating the system	With ignition switch ON (II): battery voltage (about 12 V)
34	BRN/YEL	SGND	Ground for the steering angle sensor	----
35	BLK	GND	Ground for the VSA modulator-control unit	Continuity to ground
36	BLK	MR-GND	Ground for the pump motor	Continuity to ground