APP Sensor Signal Inspection: Inspection

NOTE:

This procedure checks the APP sensor in its fully closed position. In any other position, the PCM stores the APP sensor DTCs which are covered in other troubleshooting procedures.
Check for Pending or Confirmed DTCs with the HDS before doing this procedure. If any DTCs are indicated, troubleshoot them first, then do this procedure.
Press the accelerator pedal several times to check its operation. If it does not operate smoothly, check the pedal. If you find a problem, replace the accelerator pedal module .

APP Sensor Signal - Inspect

1. Select the PGM-FI System with the HDS.

2. Make sure the accelerator pedal is not pressed, then check the APP SENSOR in the DATA LIST with the HDS.

If it is 0 %, the APP sensor is OK.
If it is not 0 %, update the PCM if it does not have the latest software , or substitute a known-good PCM , then go to step 2.

3. Make sure the accelerator pedal is not pressed, then check the APP SENSOR in the DATA LIST with the HDS.