DTC P0752

DTC P0752  : Shift Solenoid Valve A Stuck ON

DTC (Gear)

1. ATF check

   -1. Check the ATF level to make sure that the transmission is filled to the proper level, and check for fluid leaks.

   -2. Drain the ATF through a strainer. Inspect the strainer for metal debris or excessive clutch material.

   Does the strainer have metal debris or excessive clutch material?

   YES 

   Replace the transmission (e-CVT) .

   NO 

   Replace the ATF , then go to step 2.

2. Problem verification

   -1. Turn the vehicle to the ON mode.

   -2. Clear the DTC with the HDS.

   -3. Raise the vehicle on a lift. Make sure it is securely supported, and allow all four wheels to rotate freely.

   -4. Select the ENERGY FLOW screen on the MID.

   -5. Enter the VSA maintenance mode .

   -6. Run the vehicle in the engine drive mode for at least 10 seconds. Apply the brakes, and slowly bring the wheels to a stop.

   

   Do not brake hard when working on a running vehicle on a lift. It may cause some damage to the drive-line.

   -7. Check for Pending or Confirmed DTCs with the HDS.

   DTC Description	Confirmed DTC	Pending DTC	Freeze Frame
   P0752 Shift Solenoid Valve A Stuck ON

   Is DTC P0752 indicated?

   YES 

   The failure is duplicated. Go to step 3.

   NO 

   Intermittent failure, the system is OK at this time. If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the freeze data/on-board snapshot.

3. Shift solenoid valve A check

   -1. Select Shift Solenoid Valve A in the Function Test Menu with the HDS, and check that shift solenoid valve A operates.

   Shift Solenoid Test

   Is a clicking sound heard?

   YES 

   Shift solenoid valve A is OK. Faulty shift valve A. Replace the valve body assembly .

   NO 

   Replace shift solenoid valve A .