LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hummer >> 2003 >> H2 >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Infotainment >> Cellular Communication >> Repair Instructions >> Communication Interface Module Replacement >> Removal Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal Procedure

    IMPORTANT: The vehicle communication interface module (VCIM) has a specific set of unique numbers that tie the module to each vehicle. These numbers, the 10-digit station identification and the 11-digit electronic serial number, are used by the National Cellular Network and OnStar® to identify the specific vehicle. Because these numbers are tied to the vehicle identification number of the vehicle, you must never exchange these parts with those of another vehicle.
  1. Loosen and move the rearward center console for access to the center trim panel. Refer to Console Replacement in Instrument Panel, Gages and Console.
  2. Remove the screws that hold the center trim panel to the I/P. Refer to Trim Panel Replacement - Instrument Panel (I/P) Center in Instrument Panel, Gages, and Console.
    3. Fig 1: Locating Communication Interface Module Screws
    GM865083Courtesy of GENERAL MOTORS CORP.
  3. Remove the screws that hold the communication interface module to the I/P.
    4. Fig 2: Communication Interface Module
    GM865085Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the antenna and the electrical connections from the communication interface module.
  5. Remove the communication interface module.
scientia non olet · About LEMON Manuals