Installation Procedure
Courtesy of GENERAL MOTORS CORP.
- Install the clip in the slot of the seat frame.
- Install the rubber band on the clip to retain it in place.
- Fold down the seat cover.
- Install the arm rest by pressing in until it is fully seated.
- Connect the heating element wire connector.
- Set the front seat back in the forward position.
- Pull down on the seat cover in order to install the 2 push pins retaining the seat back to the card board.
- Connect the J-clip at the bottom of the seat.
- Push on the seat back cover to ensure the cover is held in place by the velcro.