LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hummer >> 2003 >> H2 >> Repair and Diagnosis >> Brakes >> Traction Control >> Antilock Brake System >> Repair Instructions >> Wheel Speed Sensor Replacement - Front >> Removal Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal Procedure

    Fig 1: View Of Wheel Speed Sensor Cable And Connectors
    GM913362Courtesy of GENERAL MOTORS CORP.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation .
  3. Remove the brake rotor. Refer to Brake Rotor - Front .
  4. Remove the WSS cable mounting clip from the knuckle.
  5. Remove the WSS cable mounting clip from the upper control arm.
  6. Remove the WSS cable mounting clip from the frame attachment point.
  7. Disconnect the WSS cable electrical connector.
    8. Fig 2: Identifying Brake/Hub Components
    GM379487Courtesy of GENERAL MOTORS CORP.
  8. Remove the wheel speed sensor (WSS) mounting bolt.
    9. NOTE: Carefully remove the sensor by pulling it straight out of the bore. DO NOT use a screwdriver, or other device to pry the sensor out of the bore. Prying will cause the sensor body to break off in the bore.
  9. Remove the wheel speed sensor (5) from the hub/bearing assembly (4).
scientia non olet · About LEMON Manuals