LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hummer >> 2003 >> H2 >> Repair and Diagnosis >> Electrical >> Charging Systems >> Battery, Charging System & Starting System >> Repair Instructions >> Battery Negative Cable Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    Fig 1: Forward Lamp Wiring Harness Ground/Negative Cable Bolt
    GM662101Courtesy of GENERAL MOTORS CORP.
  1. Install the negative battery cable.
  2. Position the negative cable and forward lamp wiring harness ring terminals to the frame.

    Insert the anti-rotation tab on the forward lamp wiring harness into the hole in the frame.

    NOTE: Refer to FASTENER NOTICE .
  3. Install the forward lamp wiring harness ground/negative cable bolt.

    Tighten:  Tighten the forward lamp wiring harness ground/negative cable bolt to 9 N.m (80 lb in).

  4. Position the negative cable and engine wiring harness ring terminals to the engine block. Position the anti-rotation tab on the negative cable in the correct location.
  5. Install the engine wiring harness ground/negative cable bolt.

    Tighten:  Tighten the engine wiring harness ground/negative cable bolt to 25 N.m (18 lb ft).

  6. Install the engine protection shield. Refer to ENGINE PROTECTION SHIELD REPLACEMENT .
  7. Lower the vehicle.
  8. Install the negative cable clip to the positive cable clip.
    9. Fig 2: View Of Battery Cables
    GM662092Courtesy of GENERAL MOTORS CORP.
  9. Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure (Single Battery) .
scientia non olet · About LEMON Manuals