LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hummer >> 2003 >> H2 >> Repair and Diagnosis >> Electrical >> Starter >> Starters >> Diagnostic System Check - Engine Electrical >> Notes
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Diagnostic System Check - Engine Electrical: Notes

  1. Did you perform the Battery Inspection/Test? If yes, go to next step. If no, go to BATTERY INSPECTION/TEST (NON-HP2) .
  2. Install a scan tool. Does the scan tool power up? If yes, go to step  4. If no, go to SCAN TOOL DOES NOT POWER UP .
    3. NOTE: The engine may start during the following step. Turn OFF the engine as soon as you have observed the Crank power mode.
  3. Access the Class 2 Power Mode in the Diagnostic Circuit Check on the scan tool. Rotate the ignition switch through all positions while observing the ignition switch power mode parameter. Does the ignition switch parameter reading match the ignition switch position for all switch positions? If yes, go to next step. If no, go to POWER MODE MISMATCH .
  4. Turn ON the ignition, with the engine OFF. Attempt to communicate with each module on the class 2 serial data circuit. If using a Tech 2, obtain this information using the Class 2 Message Monitor feature. Does the scan tool communicate with any module on the class 2 serial data circuit? If yes, go to next step. If no, go to Scan Tool Does Not Communicate with Class 2 Device in BODY CONTROL MODULES
  5. Select the Display DTCs function for each module. If using a Tech 2, use the Class 2 DTC Check feature in order to determine which modules have DTCs set. Record all of the displayed DTCs the DTC status and the module which set the DTC. Does the scan tool display any DTCs? If yes, go to next step. If no, go to SYMPTOMS - ENGINE ELECTRICAL .
  6. Does the scan tool display any DTC beginning with "U"? If yes, go to Diagnostic Trouble Code (DTC) List . If no, go to next step.
  7. Does the scan tool display any DTC beginning with "P"? If yes, go to Powertrain DTC list in Engine Controls . If no, go to next step.
  8. Does the scan tool display any DTC beginning with "B"? If yes, go to Diagnostic Trouble Code (DTC) List .
scientia non olet · About LEMON Manuals