LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hummer >> 2003 >> H2 >> Repair and Diagnosis >> External Pages >> Different car >> Section 15 (Computer Relearn Procedures) >> Ford Motor Co. >> Programming Powertrain Control Module (All Models) >> Flash Vehicle Identification (VID) Block Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Flash Vehicle Identification (VID) Block Procedure

WARNING: This page does not describe the selected car, but rather 120 other vehicles, including the 2002 Saturn Vue, 2002 Saturn SL2, 2002 Saturn SL1, 2002 Saturn SL, and 2002 Saturn SC2. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: If using a generic scan tool, follow scan tool manufacturer's instructions to perform FLASH VEHICLE IDENTIFICATION (VID) BLOCK PROCEDURE.
  1. To perform this procedure NGS scan tool, Ford Service Function (FSF) card and NGS Flash Cable (007-00531) must be used. Plug flash cable into scan tool. Plug other end of flash cable into Data Link Connector (DLC). From the scan tool main menu, select SERVICE BAY FUNCTIONS, POWERTRAIN CONTROL MODULE and then PROGRAMMABLE MODULE INSTALLATION.
  2. Scan tool display should show 2 selections. The first is selection is for old PCM information to be retrieved and stored. The second selection is for restoring new PCM with information that has been retrieved from the old PCM. Follow scan tool display instructions or refer to instruction sheet included with FSF card. If Flash Vehicle Identification (VID) Block has been reprogrammed previously, scan tool will display a message indicating the need to reflash entire Integrated Circuit (IC). This procedure can only be performed using Ford's Worldwide Diagnostic System (WDS).
scientia non olet · About LEMON Manuals