LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hummer >> 2003 >> H2 >> Repair and Diagnosis >> Steering >> Steering Column >> Steering Wheel And Column >> Repair Instructions >> Ignition Switch Replacement >> Removal Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal Procedure

    CAUTION: Refer to SIR Caution .
  1. Disable the SIR system. Refer to SIR Disabling and Enabling Zone 3 .
  2. Remove the steering wheel theft deterrent lock. Refer to Steering Wheel Theft Deterrent Lock Replacement .
  3. If equipped, remove the theft deterrent control module.
  4. Rotate the key alarm connector (1) 90 degrees.
    Fig 1: Identifying Key Alarm Connector At Ignition Lock Cylinder Case
    GM306267Courtesy of GENERAL MOTORS CORP.
  5. Gently pull the key alarm connector (2) out of the ignition lock cylinder case assembly (1).
    6. Fig 2: Identifying Ignition Switch Assembly
    GM664261Courtesy of GENERAL MOTORS CORP.
  6. Disconnect the connector from the ignition switch assembly.
  7. Remove the wires encased in the ignition switch clip, which is located on the side of the ignition switch.
  8. Remove the ignition switch assembly (2) using J 42759  . See Special Tools .
scientia non olet · About LEMON Manuals