LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hummer >> 2003 >> H2 >> Repair and Diagnosis >> Steering >> Steering Column >> Steering Wheel And Column >> Repair Instructions >> Steering Column Wire Harness Assembly Replacement >> Removal Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal Procedure

    CAUTION: Refer to SIR Caution .
  1. Disable the SIR system. Refer to SIR Disabling and Enabling Zone 3 .
  2. Remove the upper and lower trim covers. Refer to Steering Column Trim Covers Replacement .
  3. Remove the wire harness strap.
    Fig 1: Removing/Installing Plastic Mounted Steering Column Bracket
    GM761444Courtesy of GENERAL MOTORS CORP.
    4. Fig 2: Identifying Key Alarm Connector At Ignition Lock Cylinder Case
    GM306267Courtesy of GENERAL MOTORS CORP.
  4. Remove the steering wheel theft deterrent lock. Refer to Steering Wheel Theft Deterrent Lock Replacement .
  5. If equipped, remove the theft deterrent control module.
  6. Rotate the key alarm connector (1) 90 degrees.
  7. Gently pull the key alarm connector (1) out of the ignition lock cylinder case assembly (2).
  8. Disconnect the connector from the ignition switch assembly.
  9. Remove the wires encased in the ignition switch clip, which is located on the side of the ignition switch.
    10. Fig 3: View Of Steering Column And Wire Harness Assembly
    GM603937Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: If the steering wheel has steering wheel controls, the inflatable restraint steering wheel module coil and the wire harness assembly must come off as one piece. Refer to Inflatable Restraint Steering Wheel Module Coil Replacement (Coil) .
  10. Disconnect all connectors attached to the wire harness assembly.
scientia non olet · About LEMON Manuals