LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hummer >> 2003 >> H2 >> Repair and Diagnosis >> Steering >> Steering Linkage (Non-Rack & Pinion) >> Repair Instructions >> Steering Damper Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    Fig 1: Steering Damper Ball Stud Nut
    GM793268Courtesy of GENERAL MOTORS CORP.
  1. Install the steering damper.
  2. Install the new mounting bolt and a new prevailing torque nut.
  3. Install the steering damper ball stud to the relay rod.
    4. Fig 2: Seating Relay Rod Tapers
    GM689037Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE .
  4. Install the J 29193  . See Special Tools .

    Tighten the steering linkage installer in order to seat the ball stud in the relay rod.

    Tighten:  Tighten the steering linkage installer to 32 N.m (24 lb ft).

  5. Remove the J 29193  . See Special Tools .
  6. Install the prevailing torque nuts.

    Tighten: 

    • Tighten the mounting nut to 40 N.m (30 lb ft).
    • Tighten the ball stud nut to 40 N.m (30 lb ft).

  7. Install the engine protection shield. Refer to ENGINE PROTECTION SHIELD REPLACEMENT .
  8. Lower the vehicle.
scientia non olet · About LEMON Manuals