Oil Pressure Sensor: Service and Repair

Engine Oil Pressure Sensor and/or Switch Replacement
Removal Procedure
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.





2. Disconnect the oil pressure switch electrical connector (1).





3. Remove the engine oil pressure switch.

Installation Procedure





Notice: Refer to Component Fastener Tightening Notice in Service Precautions.

7. Install the engine oil pressure switch.
Tighten the switch to 20 Nm (15 ft. lbs.).





2. Connect the oil pressure switch electrical connector (1).
3. Lower the vehicle.