LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hummer >> 2007 >> H2 4D Utility Pickup >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Shift Lock Control >> Repair Instructions >> Automatic Transmission Shift Lock Actuator Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    Fig 1: Removing/Installing Shift Lock Actuator
    GM1199544Courtesy of GENERAL MOTORS CORP.
  1. In the DRIVE position, depress the shift lock actuator button and realign into the shifter lever.
  2. Push lever to NEUTRAL.
    3. NOTE: Refer to Fastener Notice .
  3. Install the top screw through the lever slot.

    Tighten:  Tighten the actuator screw to 1.65 N.m (15 lb in).

  4. Shift lever to LOW.
  5. Install the screw at the rear of the shifter assembly.

    Tighten:  Tighten the actuator screw to 1.65 N.m (15 lb in).

    6. Fig 2: Shift Lock Actuator & Electrical Connector
    GM896664Courtesy of GENERAL MOTORS CORP.
  6. Connect the electrical connector (3).
    7. Fig 3: Center Console Bolts
    GM815938Courtesy of GENERAL MOTORS CORP.
  7. Install the console. Refer to Console Replacement .
scientia non olet · About LEMON Manuals