LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hummer >> 2007 >> H3 Automatic >> Repair and Diagnosis >> Electrical >> Charging Systems >> Battery, Charging System And Starting System >> Repair Instructions >> Generator Cable Replacement >> Removal Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal Procedure

    Fig 1: Identifying Battery Cable Harness Clips
    GM1560042Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .
  2. Remove the battery cable harness clips (1, 2) from the battery tray.
    3. Fig 2: Locating Nuts Securing The Battery Cables To Underhood Fuse Block
    GM1560045Courtesy of GENERAL MOTORS CORP.
  3. Press the locking tabs inward in order to remove the underhood fuse block cover from the underhood fuse block.
  4. Remove the nut (1) securing the generator positive cable inner terminal to the underhood fuse block.
    5. Fig 3: Identifying Generator/Starter Wiring
    GM1560044Courtesy of GENERAL MOTORS CORP.
  5. Remove the left front wheelhouse liner. Refer to Wheelhouse Panel Replacement (Front) or Wheelhouse Panel Replacement (Rear) .
  6. Reposition the protective boot from the generator output BAT terminal for access.
  7. Remove the generator output BAT terminal nut (2) and disconnect the generator positive lead (1) from the generator.
  8. Remove the positive cable clip (3) from the engine wiring harness bracket.
  9. Remove the generator positive cable from the battery cables harness conduit.
scientia non olet · About LEMON Manuals