Rearview Camera Image Display Module Replacement

Fig 1: Rearview Camera Image Display Module Replacement

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures: Remove the driver knee bolster. Refer to Driver Knee Bolster Replacement (Left Hand Drive) or Driver Knee Bolster Replacement (Right Hand Drive) .
1	Rear View Camera Image Display Module Bolt NOTE: Refer to Fastener Notice . Tighten: 9 N.m (80 lb in)
2	Rear View Camera Image Display Module Nut Tighten: 9 N.m (80 lb in)
3	Rear View Camera Image Display Module Assembly Procedure Disconnect the electrical connector. Reprogram the module if replacing the unit. Refer to Control Module References .