Installation Procedure

WARNING: This page is about a different car, the 2008 Chevrolet Malibu Classic. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of BCM

Courtesy of GENERAL MOTORS CORP.

Install the BCM.
Install the BCM wire harness connectors.

NOTE: Refer to Fastener Notice .

Install the BCM screws.
Tighten: Tighten the screws to 2.5 N.m (22 lb in).
Install the right console trim panel. Refer to Front Floor Console Side Trim Panel Replacement - Right Side .
Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
For a new or remanufactured BCM, setup the BCM. Refer to Control Module References .