Removal Procedure

NOTE: After assembling the shift lock actuator, turn the ignition forward but do not start (auxiliary position) and attempt to pull the lever from PARK with and without the brake pedal depressed to verify there is no gear access without the brake pedal depressed.

NOTE: Ensure the key cannot be removed from the ignition unless both the shifter is in PARK and the shift knob button has been depressed.

Remove the console. Refer to Front Floor Console Replacement .

Fig 1: Identifying Shift Lock Actuator & Electrical Connector

Courtesy of GENERAL MOTORS CORP.

Disconnect the shift lock actuator electrical connector (3).

Fig 2: Removing/Installing Shift Lock Actuator

Courtesy of GENERAL MOTORS CORP.

Shift assembly to LOW position.
Loosen and remove the screw at the rear of the shifter assembly.
Shift the assembly to the NEUTRAL position.
Loosen and remove the top screw of the shift lock actuator through the lever slot.
Pull lever to the DRIVE position and remove the shift lock actuator.