LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hummer >> 2009 >> H3 Base, Automatic >> Repair and Diagnosis (Single Page) >> General Information >> Reset Procedures >> Programming And Setup - All Systems >> Repair Instructions >> Body Control Module Programming and Setup >> Programming the BCM
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Programming the BCM

IMPORTANT: After the procedure is completed, the personalization settings of the BCM are set to a default setting. Inform the customer that the personalization must be set again.

This vehicle uses Service Programming System (SPS) and Tech 2 pass-thru method of programming. Refer to Service Programming System (SPS)  for more information.

  1. Connect the scan tool to the vehicle in the pass-thru arrangement.
  2. Ignition ON, engine OFF.
  3. On the Techline Terminal, select Service Programming System and follow the Techline Terminal on-screen instructions.
scientia non olet · About LEMON Manuals