Installation Procedure

Fig 1: View Of Ignition Control Module

Courtesy of GENERAL MOTORS CORP.

NOTE: Ensure the ignition coil seals are properly seated to the camshaft cover.

CAUTION: Refer to Fastener Caution .

Install the ignition coil bolts.
Tighten: Tighten the bolts to 10 N.m (89 lb in).

Fig 2: View Of ECT Sensor, Fuel Injector, Ignition Coil & HO2S Engine Wiring Harness Electrical Connectors

Courtesy of GENERAL MOTORS CORP.

Connect the ignition coil connectors (3) to the ignition coils (4).
Install the air cleaner resonator and outlet duct. Refer to Air Cleaner Resonator and Outlet Duct Replacement .