LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hummer >> 2010 >> H3 Base, Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls And Fuel - 3.7L - Repair Instructions >> Repair Instructions >> Heated Oxygen Sensor Replacement - Sensor 1 >> Removal Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal Procedure

    Fig 1: ECT Sensor, Fuel Injector, Ignition Coil & HO2S Engine Wiring Harness Electrical Connectors
    GM1350694Courtesy of GENERAL MOTORS CORP.
  1. Remove the right front fender wheelhouse panel. Refer to Front Wheelhouse Liner Replacement .
  2. Disconnect the heated oxygen sensor (HO2S) electrical connector (5) from the following:
    • The engine wiring harness electrical connector
    • The camshaft cover
    3. Fig 2: HO2S In Exhaust Manifold
    GM1352009Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Excessive Force and Oxygen Sensor Caution .
  3. Using the J-39194-B:  wrench remove the HO2S from the exhaust manifold.
scientia non olet · About LEMON Manuals