Control Relay Test: 1.5L
- Remove control relay, located under left side of dashboard, near instrument panel. Using an ohmmeter, check continuity between terminals No. 3 and 8 and then terminals No. 2 and 8. See Fig 1
. Resistance should be about 95 ohms. Check continuity between terminals No. 6 and 7. Resistance should be about 35 ohms. Check continuity between relay terminals No. 1 and 4. Continuity should not exist. If continuity exists, control relay is defective. Replace control relay. If continuity does not exist, go to next step.
- Connect 12-volt battery across relay terminals No. 6 (positive) and No. 7 (negative). Continuity should exist between terminals No. 1 and 4. Disconnect battery from relay. Using an ohmmeter, check continuity between terminals No. 1 and 3. Continuity should not exist. Check continuity between terminals No. 7 and 5, and then reverse leads.
- Continuity should exist in one direction only. Connect 12-volt battery across terminals No. 5 and 7, and check continuity between terminals No. 1 and 3. Continuity should exist between terminals No. 1 and 3. If results are not satisfactory, replace control relay.
Courtesy of HYUNDAI MOTOR CO.