ISC Dc Motor (1.5L)
CAUTION:
Apply only 6 volts DC or less to ISC motor connector. Higher voltage could cause ISC motor gears to lock up.
- Disconnect ISC motor connector. Check motor coil continuity between terminals No. 1 and 2. See Figure . Resistance should be 5-35 ohms at 68°F (20°C). If resistance is zero ohms or more than specification, an open or short exists in motor coil. Replace ISC servo assembly.
- Connect 6 volts DC (four 1.5-volt DC batteries) between terminals No. 1 and 2 of ISC motor connector to operate ISC motor. DO NOT apply more than 6 volts. If motor does not operate, replace ISC motor assembly.