Brake Fluid: Service and Repair

1. Refer to bleeding procedures Service and Repair




2. Connect a vinyl tube to the bleeder screw of each wheel cylinder. Put the other end of the vinyl tube in a vessel for receiving the brake fluid.




3. Depress the brake pedal a few times. Then loosen the bleeder (with the brake pedal still depressed), and tighten if after the brake fluid stops flowing.
4. Repeat the above operation until to air bubbles are in the brake fluid.
5. Repeat these steps for the other cylinders.
6. Add fresh brake fluid up to the "MAX" level in the reserve tank.

Brake fluid DOT 3 or equivalent