LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hyundai >> 2002 >> Santa Fe Base, Automatic >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Basic Diagnostic Procedures >> Fuel System >> ECM Control Relay >> ECM Control Relay Test (Accent)
April 5, 2026: LEMON Manuals is launched! Read the announcement.

ECM Control Relay Test (Accent)

  1. Locate and remove ECM control relay, see ENGINE CONTROL RELAY LOCATION  table. Using fused jumper wire, apply battery voltage to relay terminal No. 2. Using second fused jumper wire, ground relay terminal No. 4 (component side). See Figure, and go to next step.
  2. With relay energized, check for continuity between relay terminals No. 5 and 1, also terminals No. 5 and 3 (component side). Continuity should be present until voltage is disconnected. If continuity is not as specified, replace ECM control relay.
scientia non olet · About LEMON Manuals