Visual Inspection
- Make sure ignition switch is in the OFF position and all accessories are OFF.
- Disconnect the battery cables, negative cable first.
- Remove the battery from the vehicle.
- Inspect the battery carrier for damage caused by the loss of acid from the battery. If acid damage is present, it will be necessary to clean the area with a solution of clean, warm water and baking soda. Scrub the area with a stiff brush and wipe off with a cloth moistened with baking soda and water. Clean the top of the battery with the same solution.
- Inspect the battery case, and cover, for cracks. If cracks are present, the battery must be replaced.
- Clean the battery posts with a suitable battery post cleaner.
- Clean the inside surface of the terminal clamps with a suitable battery terminal cleaning tool. Replace damaged or frayed cables and broken terminal clamps.
- Install the battery in the vehicle.
- Connect the cable terminals to the battery post, making sure the top of the terminals are flush with the top of the post.
- Tighten the terminal nut securely.
- Coat all connections with light mineral grease after tightening.