LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hyundai >> 2010 >> Azera GLS >> Repair and Diagnosis >> Body & Frame >> Ignition Switch/Steering Lock >> Ignition Switch Assembly >> Ignition Switch >> Repair procedures >> Replacement
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Repair procedures: Replacement

  1. Disconnect the negative (-) battery terminal.
  2. Remove the crash pad lower panel (Refer to the CRASH PAD ).
    Fig 1: Locating Crash Pad Lower Panel
    G06805627Courtesy of HYUNDAI MOTOR CO.
  3. Remove the ignition switch (A) after loosening the screw with IG ON and disconnecting the 6P connector.
    Fig 2: Locating Ignition Switch And Screw
    G06805628Courtesy of HYUNDAI MOTOR CO.
  4. Remove the steering column shaft (Refer to theREMOVAL ).
  5. Remove the door warning switch and key illumination lamp (A) after loosening the screws (B) and disconnecting the 6P connector.
    Fig 3: Locating Key Illumination Lamp And Screws
    G06805629Courtesy of HYUNDAI MOTOR CO.
  6. If it is necessary to remove the key lock cylinder (A), Remove the key lock cylinder (A) after pushing lock pin (B) with key ACC.
    Fig 4: Locating Key Lock Cylinder And Lock Pin
    G06805630Courtesy of HYUNDAI MOTOR CO.
  7. Installation is the reverse of removal procedure.
scientia non olet · About LEMON Manuals