Component Inspection

■ Check Related component. 

1. Connect scantool to Data Link Connector (DLC).
2. Ignition "ON" & engine "OFF".
3. Select "Diagnostic Trouble Codes (DTCs)" mode and monitor "DTC Status" parameter.
4. Check if the DTC is erased while disconnecting related component one after another.

   ■ Related component : BCM, ADM, DDM, I/F ECU, IMS (Seat, S/C)

5. Is the DTC erased?

   YES 

   • Substitute with a known-good pertinent component and check for proper operation.

     If the problem is corrected, replace pertinent component and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.

   NO 

   • Check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.